Once all cables were connected and I plugged in to a USB port, the new PC is not showing the drive at all.When I look under my Devices and Printers, the USB to SATA cable shows up, but I still cannot see or access the old drive.
Some older Sata drives have a power connection like a Pata drive ( 4 pins). If this is the case, plug in a power connector from your computers PSU as well as your adapter. USBSATA converter may be faulty or have a loose connection (check that it listed under Universal Serial Bus Controllers in device manager). The hard disc connection to the USBSATA adapter may be loose (check Disk Drives in the same place). Although the drive is spinning, it may not have enough power, so check that its listed as a drive in Disk Management. This is fairly common with 2.5 drives, particularly if they get the power from a PC, in which case you should try a USB Y lead or a separate power supply. If everything else is OK (appears, formatted etc), it may well be a drive letter conflict, in which case you should right click on it and assign it a different drive letter. Finally, as the drive is your own, Im guessing it wasnt encrypted, but just in case it didnt occur to you, could that be the problem. The best bet would be to boot up with a Linux boot CD and copy off the files you want and then you can format the drive with an extended partition to store data if you want to continue to use it. Use the power and data cables from the DVD drive for this if required. Wait few seconds and it should now say Online in the box. Converter Unable To Obtain Hardware Information Driver Letter AndIf there is no assigned drive letter, right click on the big space of your old hard drive then choose Assign drive letter or Change Driver Letter and Path. I have re-checked all connections tofrom drive and USBSATA converter (which has its own power supply). Converter Unable To Obtain Hardware Information Install Using CDDVDNext thing to try is opening up new PC and trying to install using CDDVD cables directly and if not, then trying to figure out how to boot up with Linux CD. Using Computer Management, clicked on Storage, clicked on Disk Management, the old hard drive (using a USB to SATA cable) is listed as Disk 1. When you right click you are given two options Convert to Dynamic Disk or Help. Obviously, I am trying to recover the files that are on the old hard drive (which I wanted to run a virus check on before moving any files over to the new computer). If you convert to dynamic disk, does that fix the issue are the files on the old drive then visible.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |